wharton
New Member
Starter not engaging
Posts: 5 
|
Post by wharton on Feb 20, 2018 16:52:24 GMT
Engine starts, generator works, blade works . Deven sent Pan and controller still does not move in gas or electric. 48 volt battery 40 volts after running short period. Running voltage 64 volts
Checked fuses and controller for countinity. Could issue be accelerator, drive motor controller, drive motor,?
|
|
larry
New Member
Posts: 3
|
Post by larry on Mar 11, 2018 17:00:21 GMT
I am having the exact same problem. Everything works except will not move in gas or electric mode. Was in the middle of cutting the grass and just stopped moving.
|
|
|
|
Post by nittanydoug on Mar 12, 2018 20:49:26 GMT
I had a similar issue. When getting the 2nd set of parts I was told the order to replace things.... I guess it makes a difference. At least replace all of the parts before starting it up. I was sent a pcb board and controllers. I tried it with replacing one set versus the other. It goes along the lines of a bad controller can fry a board and a bad board can fry a controller. So do both at the same time.
|
|
