lin
New Member
Posts: 1
|
Post by lin on Aug 30, 2017 17:59:44 GMT
It cranks but dose not turn over I have gone down the troubleshooting
next is battery needs to be charged
Anyone know how I can charge the 48v battery
Or know where I can get the battery charger for less than $79?
|
|
denny
Junior Member
Posts: 99
|
Post by denny on Aug 31, 2017 19:45:51 GMT
Confused. You said "it cranks but won't turn over" ?
How about it cranks but will not start?
Does it try to start, does it fire at all?
Have you checked for spark?
Have you hit it with starting fluid?
How many hours on it?
Probably fuel or spark unless something broke.
Mine would crank but not start (20 hours on the clock) Would fire briefly with starting fluid. New carburetor fixed it.
$79 is what 48V chargers are going for. Using mine a lot, running around the neighborhood on batteries.
Your location?
|
|
paulb
New Member
Posts: 12
|
Post by paulb on Oct 3, 2017 7:25:17 GMT
Mine acted up this week, but it is cooler, so I had to go under the back left side and pull the choke lever out and then it started right up. Then I put the lever back in the normal position. I hope this helps.
|
|
|
Post by crawford on Oct 3, 2017 18:58:07 GMT
one time my rocker arm came loose and push rod came out put it back in and gap it .006 been fine sense.
|
|
|
Post by puckdog on Jul 29, 2018 19:58:19 GMT
Can some send me the repair manual. As my 7100 will not go forward, or backwards.
|
|
|
Post by larrys on Aug 1, 2018 14:14:52 GMT
Not sure that will help. Couple things to start with:
Make sure it has not slipped out of one of the gears. Make sure the 48v battery is charged and connected. Will it move in F/R with the deck turned on? If yes, probably the 48v battery is bad. If no, start checking fuses and contactors to see if they are good.
|
|
|
Post by the1beertruck on May 11, 2019 16:37:57 GMT
Where can I get the correct charger cable? Does anyone have a link for it?
|
|
|
Post by Greg on May 17, 2019 1:47:20 GMT
No fire . I have the spark plug out and no fire. I tried to disconnect the magneto kill wire and no luck. The original owner gave me this thing because he was obviously sick of it...lol. I’m gonna try not to set it on fire. Any info would help. Thank you in advance.
|
|
|
Post by Shawn on May 23, 2019 0:38:03 GMT
Make sure it has enough oil. There is a kill sensor on the side
|
|
|
Post by ravenowner on May 19, 2021 0:20:47 GMT
Mine will not crank. I hear the click when key turned but no fire and no turnover. Replaced starter solenoid. Think it is the actual starter?
Best way to diagnose this?
Batteries read good. Electric mode is great.
|
|