le
New Member
Posts: 4
|
Post by le on May 24, 2020 15:02:21 GMT
I have a Red Raven 7100. I have tried all the suggestions in the forum and it still will not engage: - Safety Seat Switch -- it stopped the Raven when in motion and I raised off the seat -- so I am assuming it is functioning properly -- does anyone know if it is a two phase switch meaning different function for movement and mowing?
- Both fuses are good -- they do not look blown or at least the element is intact
- There is voltage at the plug for the mower deck
- The deck pack is fully charged
I did notice the High/low adjustment was not totally engaged for low and slipped it back in, but the mower still will not engage.
Questions: 1. Could this be the Mower engage switch? 2. Could this be the PTO Relay? 3. is there any hidden secret I am not aware of?
When this happened I was on a slight sideways incline -- it stopped one, I disengaged and re-engaged, it started and ran for 30 seconds and stopped for good.
Any suggestions?
Thank you much in advance...
|
|
|
Post by crawford on Jun 20, 2020 16:56:58 GMT
are you sure you are in low range.
|
|