|
Post by Viking man on Oct 26, 2018 14:58:27 GMT
I just tryed plugging something into generator it works. I turned off machine, flip the generator switch to off. Started and no power to generator receptacles ... so generator switch is working... still will not drive forward or reverse did anyone replay to the issue where everything works except forward and reverse
|
|
|
Post by larrys on Oct 27, 2018 12:49:29 GMT
If the unit moves when the deck is turned on then you have a 48v battery issue. If not, then you are looking at 100a fuse, contactor or DMC. Contact me by email and I'll help you walk through some checks to determine. It could me some other issues but these are the most common.
|
|
|
Post by Steve Baze on Mar 22, 2019 22:41:58 GMT
I have a Raven that is doing the same thing. It will run for a short period of time and then gets jerky and finally will not move. It does this both with the deck attached and without the deck attached. Any ideas ?
|
|
|
Post by Shawn on Mar 24, 2019 13:29:36 GMT
Go to the right side of the unit by the rear wheel. There are three fuses behind a cover. On the connector that has two fuses attached, measure the voltage on the underside of the fuse on the nut. If you have voltage, probably a drive motor controller. If not, most likely contactor, fuse, 48v battery or some other issues.
|
|
|
Post by santiagodelarosa on Mar 24, 2019 14:09:43 GMT
I had the same issue. It was the safety control under the seat. The bottom of the seat had a crack in it and whenever the seat shifted the safety would engage and cut off the mower sporadically. I took it apart and zip tied the safety. Not recommended, but it works for me.
|
|
|
Post by crawford on Mar 26, 2019 23:53:11 GMT
zip tied mine also
|
|